(Click for more information)
Type: Epoxy Polyamide
Packaging: Available in 1 gallon and 1 quart containers
Theoretical Coverage: Sq. Feet/Gallon
609 Sq. Feet at one mil dry.
203-305 Sq. Feet at recommended dry film thickness.
Calculated for mixed base and converter reduced 50%.
Coverage calculations are based on theoretical transfer efficiency of 100%.
Actual coverage rate obtained will vary according to equipment choice,
application techniques, part size, and application environment.
Recommended Wet Film Thickness: 5 mils (125 microns)
Recommended Dry Film Thickness: 2-3 mils (50-75 microns)
Recoatability: At 77F/50% R.H.
Spray: may be overcoated with itself, 4 hours; with 545 Primer or topcoat, 12
Brush Roll: with itself, 12 - 14 hours, with other products 12 - 14 hours.
Maximum without sanding: 24 Hours. May be overcoated with AWLGRIP®/AWLCRAFT®
2000 Topcoats, and 545 Epoxy Primer.
with 545 Primer before applying an AWLGRIP®/AWLCRAFT® 2000 topcoat
will maximize gloss and D.O.I. of the topcoat.
Components, Reducers, Additives, and
|Off White Base
||T0006, T0002, or T0031
Reducers or M.E.K.
Best when used as a surfacer over
other U.S. Paint Primers. May be applied by brush or roller directly to properly
prepared wood or fiberglass. Best results are obtained when these surfaces are
first sealed with 545 Primer.
Brush/Roll: Reduce mixed
D8003/D9001 as needed up to 50% with T0031.
Induction Time after Mixing: 15 Minutes
Anticipated Pot Life at 77°F/50% R.H: 8 Hours
Brush/Roller: Two coats
will be required. Light sanding between coats will improve appearance. For large
surfaces rolling, then tipping with a brush is preferred.
Do not apply paint materials to
surfaces warmer than 105°F or colder than 55°F. Do not attempt to cure
products at temperatures below 55°F.